The first thing that comes to mind when we think about Christmas lights is the holiday season. We associate them with family gatherings, presents under the tree, and the smell of cinnamon rolls baking in the oven. However, they have become much more than just decorations for our homes. In some cases they have become a burden…

… AND THAT’S WHY TUCKER ILLUMINATIONS EXISTS!

But if you REALLY want to do it yourself, here are some hints:

1. Christmas Lights

Installing Christmas Lights can be tricky and dangerous if you don’t know what you’re doing. Here’s how to safely and easily install holiday lights.

2. Safety First

Before you start, make sure you have the right tools and materials. You’ll need a screwdriver, wire stripper, pliers, tape measure, extension cord, and some electrical tape. Make sure you have enough extension cords and outlets to accommodate all the lights. Also, make sure you have a working smoke detector and carbon monoxide alarm.

3. Measure Out Your Space

The first step is to figure out where you want to put your lights. Start at the bottom of the wall and work your way up. Use the tape measure to determine the height of each bulb. If you’re using a string of lights, count the number of bulbs per foot. Then, multiply the total number of bulbs by the height of each bulb to get the total length of the string.

4. Cut the Wire

Once you’ve figured out the length of the string, cut the wires off the extension cord. Next, strip about 1/8 inch of insulation off both ends of the wires. Now, use the wire stripper to remove any remaining insulation from the wires.

5. Attach the Wires

Now that you have stripped the wires, you can attach them to the sockets. To do this, wrap the bare end of the wire around the backside of the socket. Then, twist the two together until the wire makes contact with the metal prongs inside the socket. Repeat this process for each socket.

6. Test Them All

After you’ve finished attaching the sockets, test them all to ensure they’re working properly. Plug one bulb into each socket and turn on the power. If everything works correctly, then you’re ready to move onto the next step.

7. Cover Up Any Unfinished Areas

If you didn’t finish wrapping the last few feet of wire, now is the time to cover those spots. Wrap the wire around the base of the bulb and secure it with electrical tape. Once you’ve wrapped the wire, tuck it under the bulb and trim away any excess.

Hopefully now you know it’ll be a beating without us, so…

Get a Quote | Call us at (214) 995-1917